Accessory Kit for Battery
Check the scope of delivery for completeness and any externally visible damage. Contact the Service if the scope of delivery is incomplete or damaged. Never commission the battery if components are damaged.
Components included with accessory kit
Position | Quantity | Designation |
|---|---|---|
A | 1 | APU connector set for grounding the battery cabinet and for connecting the battery management system (APU) to the battery modules |
B | 3 to 9 | Module connector set for wiring the battery modules in the battery cabinet 1) |
C | 1 | DC connector set for connecting the battery cabinet to the inverter If using more than one battery cabinet, the DC connector set is used to connect the battery cabinet to the superordinate DC distributor |
D | 1 | Temperature and humidity sensor (model SD500 from Extech Instruments) |
E | 1 | Switch |
F | 1 | Battery room label |
G | 1 | Type label |
H | 1 | Quick reference guide for SMA Commercial Storage |
1) The number of module connector sets supplied is determined by the number of battery modules: Number of battery modules - 1 = number of module connector sets supplied
APU connector set
Position | Quantity | Designation |
|---|---|---|
A1 | 1 | DC cable (with two red connectors) |
A2 | 1 | DC cable (with two black connectors) |
A3 | 1 | Communication cable |
A4 | 1 | Grounding cable for grounding the battery management system |
Module connector set
Position | Quantity | Designation |
|---|---|---|
B1 | 1 | DC cable (with one red connector and one black connector) |
B2 | 1 | Communication cable |
DC connector set
The DC connector set is intended exclusively for the connection between the battery cabinet and the battery inverter or between the battery cabinet and the DC distributor.
Position | Quantity | Designation |
|---|---|---|
C1 | 1 | DC line with one red connector (conductor cross-section: 35 mm²; length: 5 m) |
C2 | 1 | DC line with one black connector (conductor cross-section: 35 mm²; length: 5 m) |
C3 | 1 | Communication cable (length: 5 m) |
C4 | 1 | Grounding cable (length: 5 m) |
C5 | 2 | Insulated bootlace ferrule (35 mm²) |
C6 | 2 | Tube terminal lug (35 mm², M10) |
C7 | 1 | Tube terminal lug (16 mm², M8) |
C8 | 1 | Heat-shrink tubing (16 mm²) |
C9 | 1 | Heat-shrink tubing (35 mm², blue) |
C10 | 1 | Heat-shrink tubing (35 mm², red) |