Mounting the DC Distributor
Up to four battery cabinets can be connected to one inverter. In systems with more than one battery cabinet, the DC cables of the individual battery cabinets must be connected to the DC distributor. The DC distributor is connected to the battery inverter.
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or mounted.
- Transport and lift the product carefully. Take the weight of the product into account.
- Wear suitable personal protective equipment for all work on the product.
Additionally required mounting material (not included in the scope of delivery):
Four screws, washers and fastening material suitable for the support surface
Procedure:
- Pick a suitable position for mounting the DC distributor. Take the minimum clearances specified in the installation plan and the length of the supplied DC cables into account.
- Mark the position of the four drill holes and drill the holes. Use the recesses for the upper wall mounting brackets and the holes for the lower wall mounting brackets.
- If necessary, provide the 4 drill holes with suitable screw anchors.
- Mount the DC distributor on the wall.
- Ensure that the DC distributor is firmly attached.
Also see: