Disconnect the terminals on the inverter

Qualified person

To decommission the product completely upon completion of its service life, first disconnect all connections from the product.

Procedure:

  1. Disconnect the product from voltage sources ( > Disconnecting the Inverter from Voltage Sources).
    2. 11207932812
  2. Remove the AC cable from the inverter. To do so, loosen the screws (AF5) and pull the cables out of the terminal.
    3. 4904063116
  3. Remove the protection elements against contact from the terminal lugs for the DC connection. To do so, unlock the side brackets.
    4. 4904063500
  4. Remove the DC cable connection. Loosen the hex nuts (AF10) and remove the combined hexagon head screw (AF16).
    5. 11207926668
  5. Remove the network cables, the battery data cables and the signal cables from the sockets.
  6. Remove all cable glands from the connecting plate. To do so, unscrew the counter nuts from inside and remove the cable glands from the opening.
    7. 11207925772
  7. Dismantle the connecting plate. To do so, unscrew the three screws (TX40).
    8. 10876166668
  8. Position the enclosure lid. The two guide pins on the enclosure lid must slide into the guide openings on the enclosure lid.
    9. 10876167052
  9. Ensure that the cover sits straight on the enclosure.
    10. 10876167436
  10. Hold the enclosure lid pressed against the enclosure and screw and tighten the screw (hex socket AF8, torque: 18 Nm).
    11. 10876167820
  11. Place the cover on the screw in the cover of the enclosure ( > Disassembling the Inverter).

    Also see:

    Decommissioning
    Disconnecting the Connections on the Battery