Having design suggestions displayed
Requirements:
You must have opened a project and planned it up to the page Configure PV system.
You must have set the required PV arrays on the page Configure PV system.
Procedure:
- On the page Configure PV system, under Inverter design, click on the button [Design suggestions].
- The Design dialog box will open.
- If required, adjust the settings in the dialog box Design and click on [OK].
- The dialog box Design suggestions will open.
- To limit the selection of inverters, select the area Limit products and enable desired checkboxes.
- Go to the area Select inverter and enable the required checkboxes.
- Select [Recalculate].
- To change the criterion for sorting the design suggestions, select the required type of sorting from the drop-down list Sorting.
- To compare design suggestions, select [Compare selection].
- The Compare alternatives dialog box will open.
- To adopt a design suggestion, select [Adopt design] in the column of the required design suggestion.
- To save a design suggestion as an alternative design, click on [Apply as alternative] in the column of the required design suggestion.
- Above the section PV arrays, the tab Original is added and also a numbered tab Alternative for each design suggestion. In addition, the button [Compare alternatives] is added to the right of the tabs.
- To add a design suggestion as an alternative design, enable the checkboxes of the required design suggestions and click on [Add selection as an alternative].
- Above the section PV arrays, the tab Original is added and also a numbered tab Alternative for each design suggestion. In addition, the button [Compare alternatives] is added to the right of the tabs.
- To adopt a design suggestion, enable the desired design proposal and select [Adopt design].
- The selected design will be displayed in the area PV inverter.