Adding specific loads

Requirement:

  • You must have opened a project and planned it up to the project page Define load profile.

Procedure:

  1. If you are using a heat pump, activate the checkbox Heat pump in the Specific loads area and, from the drop-down list, select the use of the heated water.
  2. If desired, enable the Specified thermal power checkbox and enter the thermal power of the heat pump manually. Additionally, the Specification coefficient of performance (COP) for A2/W35 can be manually adjusted.
  3. If desired, enable the Increased self-consumption through Sunny Home Manager checkbox to further increase the self-consumption.
  4. Under Hot water requirement, enter the number of persons and the hot water requirement.
  5. Under Details of building, enter the type of building, the number of floors and the heated area of each floor.
  6. To get information on the load profile with heat pump, click on the button [Profile information]. You can only click on the button [Profile information] if the Heat pump checkbox is enabled.
    With off-grid systems: Defining the peak load
    Entering e-mobility information