Adding switchgear and measuring devices

You can add consumption meters, radio-controlled sockets, radiator controllers, I/O systems and inverters with multifunction device to your system in the device overview. The supported products can be found in the technical information "SMA SMART HOME - Compatibility list for the Sunny Home Manager 2.0" at www.SMA-Solar.com.

Detailed information on the configuration of new loads can be found under Load overview and planning ( > Load Overview and Planning).

FRITZ!DECT radio-controlled sockets automatically measure the ambient temperature near the device. The temperature is displayed on the menu page Smart Home > Temperature.

Requirements:

Procedure:

  1. Under Configuration > Device overview select the tab Overview of new devices.
  2. Select device after preselection via the device filter or in the list and activate via .
  3. The configuration wizard opens and provides the further procedure step by step.
  4. Enter the device name. You can also select and edit one of the suggestions displayed.
  5. Click on [Next].
  6. In the drop-down list select the Load that is connected to the radio-controlled socket.
    If the desired load is not available, select No assignment and then add the new load for this radio-controlled socket later.
  7. Click on [Next].
  8. A summary of your entries is displayed (see the following example).
  9. If the data are correct, click on [Finish].
  10. You are automatically forwarded to the tab New load of the configuration page Load overview and planning to configure the new load.
    Entering the PV Array Power
    Adding direct communicating loads