Adding a Device with EEBus or SEMP Interface

Requirements:

Procedure:

  1. Under Configuration > Device overview select the tab Overview of new devices.
  2. Select device after preselection via the device filter or in the list and activate via .
  3. The configuration wizard opens and provides the further procedure step by step.
  4. Enter the device name. You can also select and edit one of the suggestions displayed.
  5. Click on [Next].
  6. If the new device is basically able to take optional energy, a window will open where you have to set the priority of the load ( > Prioritizing Loads) and define the rules for switching on when optional energy is actually requested ( > Load CAN be switched on).
  7. Click on [Next].
  8. A summary of your entries is displayed.
  9. If the data are correct, select [Finish].
  10. A window appears with the message that the new device has been successfully added as a system extension.
  11. Hide the window by clicking [Close].
  12. You will automatically be taken to the New Devices Overview tab.

    Also see:

    Adding direct communicating loads
    Coupling the heat pump via EEBus