Connecting the ripple control receiver to DI 1-4


Qualified person

Procedure:

  1. Connect the connection cable to the ripple control receiver or the remote terminal unit (see the manual from manufacturer).
  2. Disconnect the charging station from voltage sources Disconnecting the product from voltage sources).
  3. Strip 6 mm of the cable insulation at maximum.
  4. 13352334604
  5. Release the conductor entries on the supplied 5-pole plug.
  6. 13352334988
  7. Connect the conductors of the connection cable to the supplied five-pole connector. To do so, plug the conductors into the conductor entries and close the conductor entries. Observe the connector assignment.
  8. 13856060812
  9. Plug the five-pole connector into the port DI 1-4 on the product. Observe the pin assignment.
  10. Ensure that the connector is securely in place.
  11. Ensure that all conductors are correctly connected.
  12. Ensure that the conductors sit securely in the terminal points.

    Also see: