Intended Use
The SMA eCharger is an AC charging station for standard-compliant charging of an electric vehicle in accordance with IEC 61851-1 MODE 3. The SMA eCharger is designed for use in private and semi-public areas with restricted access (e.g. private property, company parking lot, depot).
The product is intended exclusively for charging electric and plug-in hybrid vehicles, hereinafter referred to as "vehicle":
Mode 3 charging in accordance with IEC 61851-1 for electric vehicles with non-gassing batteries.
Socket configurations in accordance with IEC 62196.
The product meets the European standard minimum requirements for charging point labeling in accordance with EN 17186. This does not replace any additional national requirements that may have to be observed.
The product is suitable for indoor and outdoor use.
The product must only be used as stationary equipment.
The product must be tested and commissioned in fast charging mode in accordance with IEC 61851-1 before the first charging process using a suitable measuring device for charging stations.
All components must remain within their permitted operating ranges and their installation requirements at all times.
The products by SMA Solar Technology AG are not suitable for use in
Medical devices, in particular products for supplying life-support systems and machines,
Aircraft, the operation of aircraft, the supply of critical airport infrastructure and airport systems,
Rail vehicles, the operation and supply of rail vehicles and their critical infrastructure.
The above list is not exhaustive. Contact us if you are unsure whether products by SMA Solar Technology AG are suitable for your application.
The product must only be used in countries for which it is approved or released by SMA Solar Technology AG and the grid operator.
Use SMA products only in accordance with the information provided in the enclosed documentation and with the locally applicable laws, regulations, standards and directives. Any other application may cause personal injury or property damage.
The documentation must be strictly followed. Deviations from the described actions and the use of materials, tools, and aids other than those specified by SMA Solar Technology AG are expressly forbidden.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express written permission of SMA Solar Technology AG. Unauthorized alterations as well as failure to observe the documentation will void guarantee and warranty claims and in most cases terminate the operating license. SMA Solar Technology AG shall not be held liable for any damage caused by such changes.
Any use other than that described in the Intended Use section does not qualify as appropriate.
The documentation must be strictly followed. Deviations from the described actions and the use of materials, tools, and aids other than those specified by SMA Solar Technology AG are expressly forbidden.
The documentation supplied is an integral part of SMA products. Keep the documentation in a convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that apply to the installation, electrical safety and use of the product. SMA Solar Technology AG assumes no responsibility for the compliance or non-compliance with such laws or codes in connection with the installation of the product.
The type label must remain permanently attached to the product.