Configuring a heat pump as an indirectly communicating load

Qualified person

Requirement:

Procedure:

  1. Go to Device management via Configuration.
  2. In the context menu of the measuring/switching device, select Configure as load.
  3. Select the Energy load [Heat pump].
  4. In the section Integration into the energy management, activate the button Switching only.
  5. Select [Continue] to confirm.
  6. Give the load a designation in the field Device name.
  7. If the Type of load was not defined by the Energy load, select the Type of load [Heater & hot water] via the drop-down menu.
  8. Set the Priority of the load.
  9. Select [Continue] to confirm.
  10. Make the optional settings.

    Also see:

    Configuring a heat pump as directly communicating loads via EEBus interface
    Visualization of the energy management