Configuring a heat pump as directly communicating loads via the SEMP protocol

  1. Go to Device management via Configuration.
  2. Open the dialog Add devices via .
  3. Activate the button SMA device or load.
  4. Select the Energy load [Heat pump].
  5. In the section Integration into the energy management, activate the button Measuring and switching.
  6. Select [Continue] to confirm.
  7. Give the load a designation in the field Device name.
  8. If the Type of load was not defined by the Energy load, select the Type of load [Heater & hot water] via the drop-down menu.
  9. Set the Priority of the load.
  10. Select [Continue] to confirm.
  11. Make the optional settings.
    Switching the heat pump directly via compatible relay
    Configuring a heat pump as directly communicating loads via EEBus interface