Configuring a heat pump as directly communicating loads via EEBus interface

  1. Go to Device management via Configuration.
  2. Open the dialog Add devices via .
  3. Activate the button Device via EEBus.
  4. Select [Continue] to confirm.
  5. Coupling is being started.
  6. If several devices of the Sunny Home Manager 2.0 are found, select the device to be coupled.
  7. Select [Continue] to confirm.
  8. The coupling is complete.

    Also see:

    Configuring a heat pump as directly communicating loads via the SEMP protocol
    Configuring a heat pump as an indirectly communicating load