Replacing the Product with a Replacement Device

Qualified person

Under fault conditions, the product may need to be replaced. If this is the case, you will receive a replacement device from SMA Solar Technology AG. If you received a replacement device, replace the defective product with the replacement device as described below.

Procedure:

  1. Decommission the defective product ( > Decommissioning).
  2. Mount the replacement device ( > Mounting) and make the electrical connections ( > Electrical Connection).
  3. Commission the replacement device ( > Commissioning).
  4. Establish a connection to the user interface of the inverter ( > Establishing a connection to the user interface).
  5. Configure the country data set ( > Configuring the Country Data Set).
  6. If the defective product had been registered in a System Manager, replace it with the new product in the System Manager (see manual for System Manager).
  7. Pack the defective product in the packaging of the replacement device and arrange with SMA Solar Technology AG for it to be picked up.

    Also see:

    Disassembling the product
    Maintenance