Logging into the user interface as a service provider

Qualified person

After a connection to the user interface of the inverter has been established, the login page opens. Some of the parameters mentioned in this document can only be adjusted after logging in as Service provider. If you need to change these parameters, log onto the user interface as described below.

NOTICE

Property damage due to unauthorized access to the system when the standard password is used

The standard password of the product is publically available. If you use the standard password, unauthorized access to your system can be gained. Yield losses and system damage can arise as a result of unauthorized access.

  1. Replace the standard password with a secure password immediately Changing the Password.

NOTICE

Property damage due to unauthorized access to adjustable parameters

All adjustable parameters are protected by the passwords of the user groups Installer and Service provider. Providing the passwords to unauthorized persons can lead to incorrect parameters being input, resulting in damage to devices and system malfunctions. The user group User does not require a password and can view current values and device information without logging in. The user group User cannot change any settings.

  1. Only give the passwords for the user groups Installer and Service provider to qualified persons.

NOTICE

Adjusting of parameters that are not described will void the warranty

After logging in as Service provider, parameters can be set that can affect the function of the inverter and the overall system. Adjusting these parameters can result in the damage of system components or in unwanted system behavior. Adjusting parameters other than those described in the documentation will void the warranty.

  1. After logging in on the user interface as Service provider, only adjust the parameters described in the documentation as described in the documentation.
  2. Only change parameters if necessary.

Requirements:

Procedure:

  1. Click on [Login] in the top right.
  2. Enter the password in the field Password. The standard password for the user group Service provider is pw8888.
  3. Click on [Login].

    Also see:

    Logging into the user interface as an installer
    Logging out of the user interface