Requirements for Mounting

Requirements for the installation site:

WARNING

Danger to life due to fire or explosion

Despite careful construction, electrical devices can cause fires. This can result in death or serious injury.

  1. Do not mount the product in areas containing highly flammable materials or gases.
  2. Do not mount the product in potentially explosive atmospheres.

Requirements:

  • A solid, flat support surface must be available for mounting.

  • The support surface for installation must be made of a non-flammable material.

  • Installation must be carried out so that the connector of the charging cable is always at a height of 0.5 m to 1.5 m above floor level.

  • The installation site must be suitable for the weight and dimensions of the product ( > Technical Data).

  • The installation site must not be exposed to direct solar irradiation. If the product is exposed to direct solar irradiation, the exterior plastic parts might age prematurely and overheating might occur. When becoming too hot, the product reduces its power output to avoid overheating.

  • The installation site must be less than 2000 m above Mean Sea Level

  • The installation site must be selected so that the EV Charger and the vehicle can be connected with the charging cable. The charging cable must not be strained, squeezed or bent.

  • No other device may be installed under the product.

  • The installation site should be freely and safely accessible at all times without the need for any auxiliary equipment (such as scaffolding or lifting platforms). Non-fulfillment of these criteria may restrict servicing.

  • All ambient conditions must be met ( > Technical Data).

Permitted and prohibited mounting positions:

  • The product may only be mounted in a permitted position. This will ensure that no moisture can penetrate the product.

  • The product should be mounted in such way that display messages and LED signals can be read without difficulty.

8643414284

Permitted and prohibited mounting positions

8643414668

Permitted and prohibited mounting positions

Dimensions for wall mounting:

8643415052

Position of the anchoring points (Dimensions in mm)

Accessories for charging stand mounting:

8643415820

Charging stand dimensions (Dimensions in mm)

Recommended clearances for wall mounting:

  • Maintain the recommended clearances to walls as well as to other charging stations, inverters or objects.

  • If multiple products are mounted in areas with high ambient temperatures, increase the clearances between the products and ensure sufficient fresh-air supply.

8643842700

Recommended clearances (Dimensions in mm)

Recommended clearances for charging stand mounting:

8643843084

Recommended clearances (Dimensions in mm)

    Mounting
    Wall Mounting