Mounting the WLAN Antenna

Qualified person

If the Wi-Fi range is insufficient, the signal can be enhanced with a Wi-Fi antenna.

Additionally required material:

Procedure:

Disconnect the inverter from all voltage sources ( > Check that the inverter is de-energized).
Remove the filler plug from the middle enclosure opening.

Insert the M32x1.5 cable gland with four-hole cable support sleeve for communication connections into the enclosure opening at the center and tighten it from the inside with the counter nut.
Unscrew the union nut from the cable gland and lead the cable through.
Remove the four-hole cable support sleeve from the cable gland.
Insert the cable into a fitting enclosure opening of the four-hole cable support sleeve. In doing so, pierce the closed side of the enclosure opening.
Press the four-hole cable support sleeve with the cable into the cable gland.
Plug the Wi-Fi antenna cable into the socket and screw tight (tightening torque: 1 Nm).
Ensure that the cable is secure by gently pulling on it.
Tighten the swivel nut on the cable gland hand-tight.
Install the antenna as far away as possible from the inverter in order to achieve a wide Wi-Fi range. Do not attach the antenna to the enclosure of the inverter.
Information: The appropriate Wi-Fi antenna is automatically selected depending on the connection quality. The currently active antenna is displayed via the instantaneous value WiFi antenna type.

Also see: