Changing parameters
The parameters of the product are set to certain values by default. You can change the parameters to optimize the performance of the product.
This section describes the basic procedure for changing parameters. Always change parameters as described in this section.
Accepting the settings
Saving the made settings is indicated by an hourglass symbol on the user interface. If the DC voltage is sufficient, the data is transferred directly to the inverter and accepted. If the DC voltage is too low (e. g. in the evening), the settings are saved, but they cannot be directly transferred to or accepted by the inverter. As long as the inverter has not yet received and accepted the settings, the hourglass symbol will continue to be displayed on the user interface. The settings will be accepted when there is sufficient DC voltage applied and the inverter restarts. As soon as the hourglass symbol appears on the user interface, the settings have been saved. The settings will not be lost. You can log off of the user interface and leave the system.
Requirements:
You are logged in on the user interface.
Changes to grid-relevant parameters must be approved by the responsible grid operator.
Procedure:
- Call up the menu Device parameters.
- Click on [Edit parameters].
- Expand the parameter group that contains the parameter which is to be configured.
- Change the required parameters.
- Select [Save all] to save the changes.
- The parameters are set.
Also see: