Additionally Required Materials and Equipment

Profile rail (length: min. 1100 mm, depth: max. 60 mm, height: 50 mm to 80 mm)

2

Required exclusively if the product is intended to be mounted using a profile rail

Threaded ring (M12)

2

Only required if the product is to be transported with a lifting gear

Heavy-duty anchor (M10x95)

4

Only required if mounted without profile rails: For mounting the device on a wall

Ring terminal lugs (M12)

5

To attach to the AC connection cables

Ethanol cleaning agent

1

Used to clean terminal lugs

Protective grease

1

Only required if cable is made of aluminum: Used to apply to aluminum conductor

Network cable

1

To establish communication with the product

Field-assembly RJ45 connector.

2

Only required if self-assembly network cable is used

Means of transport (e.g., pallet truck)

1

Used to transport packed product to installation site

Lifting gear

1

Only required if the product is to be transported with a lifting gear

Utility knife

1

Used to unpack the product

Flat-blade screwdriver (4 mm)

1

For loosening the sealing screw on the attachment bars of the inverter

Phillips screwdriver (PH2)

1

For attaching the connecting rod at the bracket parts for the mounting bracket

Tape measure

1

For measuring the distances between bore holes for mounting

Marker pen

1

For marking the bore holes for mounting

Hammer drill with Ø 12 mm and Ø 14 mm drill bit

1

For drilling the bore holes for mounting

Spirit level

1

For aligning the mounting bracket

Rubber mallet

1

Only required if mounted without profile rails: For securing the expanding screws for mounting

Wrench (AF16)

1

Only required if mounted with profile rails: For attaching the mounting bracket

Socket wrench with 16 mm insert

1

Only required if mounted with profile rails: For attaching the mounting bracket

Phillips screwdriver (PH3)

1

For attaching and securing the product to the mounting bracket

Cable cutter

1

For trimming cables

Insulation stripping tool

1

For insulating the cable for the AC connection

Press tool

1

For attaching the ring terminal lugs to the cables of the AC connection

Hot-air blower

1

For attaching the heat-shrink tubings to the AC conductors

Socket wrench with deep sockets (AF18)

1

For releasing and fastening the conductors with ring terminal lugs in the AC cable compartment

Clean cloth

1

Used to clean terminal lugs

Brush

1

Only required if mounted with profile rails: For cleaning the aluminum conductors

Wrench (AF33)

1

For loosening and attaching the swivel nut of the communication connection

Voltage detector with a measurement range designed for the maximum AC and DC voltage of the inverter

1

For verifying that no voltage is present

Current clamp

1

For verifying that no current is present