Overview of compatible products

Availability of SMA products in your country

Not all SMA products are available in all countries. For information on whether an SMA product is available in your country, contact your distributor.

Inverter

  • SMA inverters with integrated or retrofitted Speedwire/Webconnect interfaces are supported. Information on whether an SMA inverter has an integrated Speedwire/Webconnect interface or can be retrofitted with a Speedwire/Webconnect interface can be found on the product page of the respective SMA inverter at www.SMA-Solar.com.

  • SMA inverters with SMA Data1 (via RS485 bus) are supported for the control and monitoring operating modes. Information on whether an SMA inverter communicates via SMA Data1 can be found on the product page of the respective SMA inverter at www.SMA-Solar.com.

  • FLX and TLX series inverters with Danfoss EtherLynx protocol from Danfoss Solar Inverters A/S

  • Inverter with SunSpec Modbus interface. Information about whether an inverter has a SunSpec Modbus interface can be found in the manual or additional information on the inverter.

Additional supported products

Energy meters:

  • SMA Energy Meter from firmware version 1.1

  • DTS 307 from Measurlogic, Inc.

  • PAC2200 from Siemens (only as consumption meter)

  • Power Analyser of the UMG 604 series from Janitza electronics GmbH

  • UMD 705 from PQ Plus GmbH

  • WattNode Modbus of the WNC series from Continental Control Systems, LLC

  • WattsOn-Mark II Precision Energy Meter from Elkor Technologies Inc.

Additional energy meters can be added via user-defined Modbus profiles.

External I/O Systems:

  • ioLogik E1214 from Moxa Europe GmbH

  • ioLogik E1241 from Moxa Europe GmbH

  • ioLogik E1242 from Moxa Europe GmbH

  • ioLogik E1260 from Moxa Europe GmbH

  • WAGO-I/O-SYSTEM 750 of WAGO Kontakttechnik GmbH & Co. KG

Sensors (via Modbus interface):

  • Irradiation sensors

  • Anemometers

  • Temperature sensors

  • Fill-level sensors (display in %)

  • Weather stations (e.g. PVMET-200 from RainWise, Inc.)

Sensors (directly connected or via external I/O systems):

  • Irradiation sensors that can output a current signal in the range from 0 mA to 20 mA (directly connected) or 4 mA to 20 mA (external I/O systems)

  • Anemometers that can output a current signal in the range from 0 mA to 20 mA (directly connected) or 4 mA to 20 mA (external I/O systems)

  • Temperature sensors with a Pt100 measuring shunt

The linearization of the temperature sensors' data takes place in the I/O system. In the case of solar irradiation sensors and anemometers, however, the sensor itself must be designed for a linearization of the data.

Sensors (via connected SMA inverters):

The following sensors that are connected to an SMA inverter are supported (for connection options see the inverter manual):

  • Irradiation sensors

  • Anemometers

  • Temperature sensors

Signal receivers and digital signal sources:

  • Signal sources with relay contacts

Routers and network switches:

Energy monitoring

  • Routers and network switches for Fast Ethernet with a data transfer rate of at least 100 Mbit/s. All network components used must support version 2 or version 3 (IGMPv2 or IGMPv3) of the IGMP protocol. Do not use an IGMP Snooping Switch as per RFC 4541.

E-mobility:

    Product overview
    Device function