Operating manual
SMA DATA MANAGER M
EDMM-20
- Information on this Document
- Safety
- Scope of delivery
- Product overview
- Mounting
- Connection
- Requirements for the Connection
- Connection cable requirements for power supply terminal X1
- Signal cable requirements for fast stop X2
- Signal cable requirements for multifunction relay X3
- Signal cable requirements for analog terminals X4 to X7
- Signal cable requirements for temperature input X8
- RS485 X9 cable requirements
- Signal cable requirements for digital terminals X10 to X13
- Network cable requirements X14 to X16
- Connection cable requirements for power supply terminal X1
- Overview of the Connection Area
- Preparing the Connection Cable
- Terminal for fast stop X2
- Connection to the multifunction relay X3
- Connection to the analog output X4/X5
- Connection to the analog input X6/X7
- Connection to temperature input X8
- Connection to the RS485 X9 input
- Connection to digital input X10
- Connection to digital input X11
- Connection to the multifunction relay X12/X13
- Connection to the system network X14/X15
- Connection to the Internet X16
- Connection to the voltage supply X1
- Requirements for the Connection
- Commissioning
- Operation
- Design of the User Interface
- Access rights to the user interface
- Device Administration
- Backup file
- Resetting the product to default setting
- Deleting the Admin Account
- Firmware Update
- Grid management service
- Modbus
- Limiting-value based switching
- Speedwire encryption
- Fallback Behavior
- Replace the SMA Data Manager M (EDMM-10) with the SMA Data Manager M (EDMM-20)
- Design of the User Interface
- Troubleshooting
- Obsolete or incorrect measured values are displayed
- Not all devices are being detected
- The product user interface cannot be called up
- Parameter changes via the device settings or a parameter adjustment are not confirmed
- The product cannot be registered in Sunny Portal
- The firmware of a connected SMA product was not updated during a firmware update
- No data are displayed on the user interface of the product
- Obsolete or incorrect measured values are displayed
- Decommissioning the Product
- Disposal
- Technical Data
- Accessories
- Compliance Information
- EU Declaration of Conformity
- Contact