Connecting the remote terminal to X4/X5

Qualified person

Requirements:

Procedure:

  1. Connect the connection cable to the analog remote terminal (see the manual from manufacturer).
  2. Remove the sheath from the connection cable.
  3. Fold the surplus cable shield back over the cable sheath.
  4. Strip the insulation off the wires.
  5. Connect the connection cable to the supplied 2-pole connector. Ensure that the conductors are plugged completely into the terminal points up to their insulation.
  6. Plug the 2-pole connector into the socket X4/X5 on the product. Observe the pin assignment.
  7. Ensure that the connector is securely in place.
  8. Ensure that all conductors are correctly connected.
  9. Ensure that the conductors sit securely in the terminal points.
  10. Fit the cable shield onto an external shielding clamp.

    Also see:

    Circuitry overview X4/X5
    Connection to the analog input X6/X7