Connecting signal source to X3

Qualified person

Requirements:

Procedure:

  1. Connect the connection cable to the digital signal source (see the manual from manufacturer).
  2. Connect the connection cable to the supplied two-pole plug. Ensure that the conductors are plugged completely into the terminal points up to their insulation.
  3. Plug the 2-pole connector into the socket X3 on the product. Observe the pin assignment.
  4. Ensure that the connector is securely in place.
  5. Ensure that all conductors are correctly connected.
  6. Ensure that the conductors sit securely in the terminal points.

    Also see:

    Circuitry overview X3
    Connection to the analog output X4/X5