Supported Products

Supported SMA Products

Availability of SMA products in your country

Not all SMA products are available in all countries. For information on whether an SMA product is available in your country, contact your distributor.


  • All SMA inverters with integrated or retrofitted Speedwire/Webconnect interfaces are supported. Information on whether an SMA inverter has an integrated Speedwire/Webconnect interface or can be retrofitted with a Speedwire/Webconnect interface can be found on the SMA inverter product page at

Additional products:

Supported Products from Other Manufacturers


  • FLX and TLX series inverters with Danfoss EtherLynx protocol from Danfoss Solar Inverters A/S

Energy meters:

  • DTS 307 from Measurlogic, Inc.

  • PAC2200 from Siemens (only as consumption meter)

  • Power Analyser of the UMG 604 series from Janitza electronics GmbH

  • UMD 705 from PQ Plus GmbH

  • WattNode Modbus of the WNC series from Continental Control Systems, LLC

  • WattsOn-Mark II Precision Energy Meter from Elkor Technologies Inc.

External I/O Systems:

Sensors (via Modbus interface):

  • Irradiation sensors

  • Anemometers

  • Temperature sensors

  • Fill-level sensors

  • Weather stations (e.g. PVMET-200 from RainWise, Inc.)

Sensors (in conjunction with external I/O systems):

  • Irradiation sensors that can output a current signal in the range from 4 mA to 20 mA

  • Anemometers that can output a current signal in the range from 4 mA to 20 mA

  • Temperature sensors with a Pt100 measuring shunt

The linearization of the temperature sensors' data takes place in the I/O system. In the case of solar irradiation sensors and anemometers, however, the sensor itself must be designed for a linearization of the data.

Sensors (via connected SMA inverters):

The following sensors that are connected to an SMA inverter are supported (for connection options see the inverter manual):

  • Irradiation sensors

  • Anemometers

  • Temperature sensors

Signal receivers and digital signal sources:

  • Signal sources with relay contacts

Routers and network switches:

  • Routers and network switches for Fast Ethernet with a data transfer rate of at least 100 Mbit/s. All network components used must support version 2 or version 3 (IGMPv2 or IGMPv3) of the IGMP protocol. Do not use an IGMP Snooping Switch as per RFC 4541.

E-mobility (optional licensed function SMA Charge S can be purchased)

  • EEBUS compatible charging station for electric vehicles (e.g. Audi e-tron charging system connect)