Commissioning the battery modules

Qualified person

Requirements:

  • The battery modules must be correctly mounted.

  • All cables must be correctly connected.

  • The inverter must be equipped to be compatible with the battery and the firmware version required at a minimum (see technical information "Approved Batteries and Information on Battery Communication Connection" of the inverter).

Procedure:

  1. Open the cover of the DC switch on each battery module. The side cover must not be mounted for this.
    2. 13174679180
  2. Turn on the DC switches one after the other.
  3. The green LED is glowing or flashing.
  4. The blue LED is flashing first and starts glowing once a connection has been successfully established.
  5. Close the cover of the DC switch on each battery module.
    6. 15275296780
  6. Optional: Attach the cover to the top battery module. Then, attach the top cover on the upper battery enclosure with the two cutouts onto the carrying handles.
    7. 13174679564
  7. Attach the side covers. For each side cover, insert the 4 guide pins on the side cover into the 4 guide openings on the battery enclosure.
    8. 13403986572
  8. Push each side cover against the battery enclosure until it snaps into place.
  9. Attach the second side cover in the same way as described for the first one.
  10. Commission the inverter (see product manual).

    Also see:

    Checking the Mounting and Connection Work
    Checking the configuration of the battery modules on the user interface of the inverter