Use of the digital output (MFR)
The digital output (MFR) can be switched depending on measured values or states.
You have several options to use the digital output.
Possible use | Category | Explanation |
|---|---|---|
Notification in the event of an error | System state | System is in warning or error state. |
Alarm in case of warning or error | System state | System is in error state. |
Direct selling enabled | System state | The active power limitation of the direct seller is currently used for the point of interconnection. |
Battery state of charge1) | Monitoring | Balanced state of charge of all batteries in the system |
System active power1) | Monitoring | Sum of the active power of all PV inverters in the system. |
System reactive power1) | Monitoring | Balance of the reactive power of all selected PV inverters in the system. |
Reactive power setpoint1) | Setpoints | Reactive power value to be set. |
Setpoint of active power limitation1) | Setpoints | The active power value currently to be set. |
Standardized measured voltage value for Q(V)1) | Grid connection point | Standardized measured voltage value from the point of interconnection. For this, you require a valid Q(V) configuration in the grid management services. |
System active power (grid-supplied power)1) | Grid connection point | Currently drawn active power. |
System active power (grid feed-in)1) | Grid connection point | Currently fed-in active power. |
System reactive power at the grid connection point1) | Grid connection point | Current reactive power. |
1) Conditions for activating the outlet signal must be specified