Procedure when Replacing a Battery

When a connected battery is replaced by a new battery, the battery configuration must be performed.

Procedure:

  1. Disconnect the inverter from all voltage sources ( > Disconnecting the Inverter from Voltage Sources).
  2. Connect new battery (see ( > Connecting the power cable of the battery) and ( > Connecting CAN communication cable)).
  3. Recommission the inverter Commissioning the Inverter.
  4. Open the user interface ( > Establishing a connection to the user interface).
  5. Log in as Installer.
  6. Start the installation assistant ( > Starting the Installation Assistant).
  7. Click on [Save and next] for each step up to the step Battery configuration.
  8. The new battery has been automatically detected and is already configured.
  9. Select Save and next until the Summary is displayed.
  10. Check the configuration in the summary.
  11. Select Next.
  • The battery configuration is being updated. The new battery is captured.
    Decommissioning the Inverter
    Procedure for Receiving a Replacement Device