Setting the P(f) characteristic curve

The characteristic curve is preset according to country data set. You can make adjustments via parameter settings. Coordinate the configuration with your grid operator.

The basic procedure for changing operating parameters is explained in another section ( > Changing Operating Parameters).

Procedure:

  1. Set the parameter Number of used interpolation points in the parameter group System and device control > Inverter > Conf. of the grid integr. characteristic curves > Characteristic curve.
  2. Enter the values for the interpolation points in the parameter group System and device control > Inverter > Conf. of the grid integr. characteristic curves > Interpolation points of the characteristic curve 3.
    Setting the P(V) characteristic curve
    Operating Modes of the Multifunction Relay