Integrating the Inverter into the Network


If the router supports DHCP and DHCP is enabled, the inverter will automatically be integrated into the network. You will not need to carry out network configuration.

If the router does not support DHCP, automatic network configuration will not be possible and you will need to use the SMA Connection Assist to integrate the inverter into the network.

Requirements:

  • The inverter must be in operation.

  • There must be a router with Internet connection in the local network of the system.

  • The inverter must be connected to the router.

Procedure:

  • Integrate the inverter into the network by means of the SMA Connection Assist. Download the SMA Connection Assist and install it on the computer (see www.SMA-Solar.com).