Retrofitting the Surge Arrester Type II
Qualified person
The inverter is equipped ex works with surge arresters or it can be retrofitted ( > Spare Parts and Accessories).
- Disconnect the inverter from all voltage sources ( > Disconnecting the Inverter from Voltage Sources).
- Wait 20 minutes before you remove the DC protective cover to allow residual voltages to discharge.
- Release the screws on the DC protective cover using an Allen key (AF 3), lift the DC protective cover upwards from below and remove it.
- Plug the new surge arresters into the designated slots until they lock into place with the locking tabs. The inspection window must be located on the right-hand side.
- Position the DC protective cover at the upper edge, flip down and tighten it (torque: 3.5 Nm).
DANGER
Danger to life due to high voltages

