Cleaning the Fan on the Left-Hand Side of the Enclosure
Qualified person
- Disconnect the inverter from all voltage sources ( > Disconnecting the Inverter from Voltage Sources).
- Remove the ventilation grids on the left-hand and right-hand sides and clean them:
Turn the rotary fastener of the ventilation grid with a flat-blade screwdriver until the notch is in a vertical position.
Remove the ventilation grid. Use a screwdriver to gently lever open the ventilation grid.
Clean the ventilation grid with a soft brush, a paint brush, or compressed air.
- Do not remove the ventilation grids permanently, otherwise, foreign bodies could penetrate the enclosure.
- Wait for the fan to stop rotating.
- Press the locking tabs of the fan to the center of the fan.
- Carefully remove the fan from the inverter.
- Release and disconnect the fan plug.
- Clean the fan only with a soft brush, paint brush or damp cloth.
- After cleaning, insert the fan plug into the pin connector until it snaps into place.
- Insert the fan into the inverter until it snaps into place.
- Attach the ventilation grids on the right-hand and left-hand sides of the inverter:
Reinsert the ventilation grid until it snaps into place.
Turn the rotary lock on the ventilation grid with a flat-blade screwdriver until the slot is in a horizontal position and the arrows point to the right.
Ensure that the ventilation grid is securely in place.
- Recommission the inverter ( > Commissioning the Inverter).
- Check the fans to ensure that they are working properly ( > Checking the Function of the Fans).