Configuring the System with the SMA 360° App

Requirement:

  • All system components must be switched on (see manual of the products).
  • The latest firmware must be installed on all system components.
  • All system components must be located in the same network.
  • An SMA ID must be available.

    Procedure:

    1. Download the SMA 360° App from the App Store or Play Store.
    2. Open the SMA 360° App and log in with the SMA ID.
    3. If a system consists of multiple products and Wi-Fi is to be used for configuration, the subordinate devices must each be connected to the network separately. In the SMA 360° app, go to Setup > Network setup to establish a Wi-Fi connection with the product. Follow the instructions. When requested by the app, scan the QR code of the product. It can be found on the type label of your product. Perform this process for each subordinate device within the system.
    4. To start the commissioning wizard, go to Setup > Commissioning.
    5. Follow the SMA 360° app instructions and scan the QR code on the product's cover when prompted by the app to configure it as the System Manager.
    6. Select the Inverter as System Manager in the device settings, then continue with the app instructions.
    7. The Sunny Home Manager 2.0 or an SMA Energy Meter is detected during commissioning.
    8. The battery is detected during commissioning.
    9. The SMA backup solution is detected during commissioning.
    10. The SMA eCharger is detected during commissioning.
      Switching on the Battery
      Checking the Battery Configuration via the Inverter User Interface