Intended Use

The accessory kit "SC-UP silencer complete" is an accessory for the noise reduction of SMA inverters.

The product must only be installed in the following SMA inverters:

  • SC xxxx UP

  • SC xxxx UP-US

  • SCS xxxx UP

  • SCS xxxx UP-US

  • SCS xxxx UP-XT

  • SCS xxxx UP-XT-US

  • EC UP-LV

  • EC UP-LV-US

  • EC UP-HV

  • EC UP-HV-US

The same requirements on ambient conditions apply to the installation and operation of the noise reduction products as for the respective inverter. You can find further information in the documentation for the inverter.

The roof of the inverter must be removed so that the noise reduction products can be installed. The inverter without roof must be protected from ambient influences such as direct rain or snow. The inverter can be protected by a tarpaulin, or stored in a sheltered place.

Use SMA products only in accordance with the information provided in the enclosed documentation and with the locally applicable laws, regulations, standards and directives. Any other application may cause personal injury or property damage.

Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and warranty claims and in most cases terminate the operating license. SMA Solar Technology AG shall not be held liable for any damage caused by such changes.

Any use of the product other than that described in the Intended Use section does not qualify as appropriate.

The documentation supplied is an integral part of SMA products. Keep the documentation in a convenient, dry place for future reference and observe all instructions contained therein.

This document does not replace any regional, state, provincial, federal or national laws, regulations or standards that apply to the installation, electrical safety and use of the product. SMA Solar Technology AG assumes no responsibility for the compliance or non-compliance with such laws or codes in connection with the installation of the product.

The product must not be operated with any technical defects.

The type label must remain permanently attached to the product.

    Safety
    Safety Information