Mounting the Inverter on the Wall


To mount the inverter on the wall, proceed as follows.

Additionally required mounting material (not included in the scope of delivery):

  • The mounting material must be made of stainless steel.
  • Two screws suitable for the support surface
  • Two washers suitable for the screws
  • Two screw anchors suitable for the support surface and the screws

Procedure:

  1. CAUTION

    Risk of injury due to damaged cables

    There may be power lines or other supply lines (e.g. gas or water) routed in the wall.

    1. Ensure that no lines are laid in the wall which could be damaged when drilling holes.
  2. Mark the position of the drill holes using the holes in the enclosure. For this, use the two outer holes or the two oblong holes in the middle.
  3. Drill the holes and insert the screw anchors.
  4. 872427660
  5. Align the inverter with the drill holes and attach it using suitable screws and washers.