Changing Operating Parameters

This section describes the basic procedure for changing operating parameters. Always change operating parameters as described in this section.

The operating parameters of the Sunny Multigate are set to certain values by default. You can change the operating parameters after commissioning using Sunny Explorer to optimize the operation of the inverter.

Requirements:

  • The PV system must be commissioned ( > Commissioning the PV System).
  • A computer with an Ethernet interface must be available.
  • Sunny Explorer from software version 1.06 must be installed on the computer.
  • The system must be registered in Sunny Explorer.
  • The changes to the grid-relevant parameters must be approved by the responsible grid operator.
  • When changing grid-relevant parameters, the SMA Grid Guard code must be available (see the Certificate ""Application for SMA Grid Guard Code"" at www.SMA-Solar.com).

Procedure:

  1. Access the Sunny Explorer user interface.
  2. If required, enter the SMA Grid Guard code.
  3. Select and set the desired parameter.
  4. Save settings.
    <  Connecting the Sunny Multigate to Sunny Explorer
    >  Configuring the Country Data Set