LED Signals
The LEDs indicate the operating state of the product.
LED signal | Explanation |
|---|---|
|
The green LED is flashing slowly (2 seconds on and 2 seconds off) |
Waiting for start conditions The conditions for charging operation are not yet met. As soon as the conditions are met, the EV Charger will start charging operation. |
|
The green LED is flashing fast: 0.5 s on and 0.5 s off |
Software update The product is carrying out a software update. |
|
The green LED is glowing |
Charge mode The EV Charger charges the vehicle at more than 90% of its nominal power. |
|
The green LED is pulsing |
Charge mode The EV Charger is equipped with a dynamic power display via the green LED. Depending on the power, the green LED pulses fast or slow. |
|
The green LED is off |
The EV Charger does not perform any charging process. |
|
The red LED is glowing |
Event occurred If an event occurs, a distinct event message and the corresponding event number will be displayed in addition on the product user interface or in the communication product (e.g. Sunny Home Manager). |
|
Red LED flashing |
Charging mode was interrupted by vehicle. If this event occurs, the vehicle has interrupted the charging process. Corrective measures:
|
The blue LED flashes slowly for approx. 1 minute | Communication connection is being established The product is establishing a connection to a local network or is establishing a direct connection to a smart device via Ethernet (e.g. smartphone, tablet or laptop). |
|
The blue LED flashes quickly for approx. two minutes (0.25 s on and 0.25 s off). |
WPS active The WPS function is active. |
The blue LED is glowing | Communication active There is an active connection with a local network or there is a direct connection via Ethernet with a smart end device (e.g. smartphone, tablet or laptop). |
|
All 3 LEDs light up and go out after about 90 seconds |
Start phase of charging operation When the LEDs are off again, the start phase is complete and charging begins. |