Mounting the product
Additionally required material (not included in the scope of delivery):
3 stainless steel hexagon head wood screws (AF 10, diameter 6 mm), screw length must be suitable for the support surface and the weight of the product (fastening bracket thickness: 4 mm)
1 washer (diameter: 6 mm)
Where necessary, 3 screw anchors suitable for the support surface and the screws
CAUTION
Risk of injury due to weight of product
Injuries may result if the product is lifted incorrectly or dropped while being transported or mounted.
- Wear suitable personal protective equipment for all work on the product.
Procedure:
- Mark the position of the drill holes. Align the markings horizontally.
- Drill the holes.
- Insert screw anchors into the drill holes if the support surface requires them.
- Insert the screws until there is at least 6 mm clearance between the screw head and the support surface.
- Remove the brown adhesive tape from the product.
- Attach the mounting bracket with conical spring washer and hexagon socket cap head screw to the product (torque: 6 Nm ± 0.3 Nm).
- Hang the product onto the screws using the metal brackets.
- Insert hexagon head screw with washer through the mounting bracket and tighten with a suitable tool (torque: 6 Nm ± 0.3 Nm).
- Tighten the screws hand-tight using a ratchet or box wrench. When doing this you can compensate for any misalignment of the drill holes by aligning the metal brackets accordingly.
- Ensure that the product is securely in place.
