Interfaces and Functions
The product is equipped with the following interfaces and functions:
User interface for configuration and monitoring
The product is equipped as standard with an integrated webserver, which provides a user interface for configuring and monitoring the product.
Once the connection has been established to the smart device, use a terminal (e.g. smartphone, tablet or laptop) to connect to the product's user interface using a web browser.
SMA Speedwire
The product is equipped with SMA Speedwire as standard. SMA Speedwire is a type of communication based on the Ethernet standard. SMA Speedwire is designed for a data transfer rate of 100 Mbps and enables optimum communication between Speedwire devices within systems.
The products supports the encrypted system communication with SMA Speedwire Encrypted Communication. In order to be able to use the Speedwire encryption in the system, all Speedwire devices, except for the SMA Energy Meter, must support the function SMA Speedwire Encrypted Communication.
Wi-Fi connection to SMA 360° app and SMA Energy app
There is a QR code on the product by default. By scanning the QR Code attached to the product via the SMA 360° app or SMA Energy app, access to the product is established via Wi-Fi and the connection to the user interface is made automatically.
Wi-Fi
The product is equipped with a Wi-Fi interface as standard. The inverter is delivered with the WLAN interface activated as standard. If you do not want to use WLAN, you can deactivate the WLAN interface.
In addition, the product has a WPS function. The WPS function is for automatically connecting the product to a network (e.g. via router) and establish a direct connection between the product and a smart end device.
Limited function in the event of frost
The integrated Wi-Fi interface of the product is only designed for temperatures down to -20°C.
- Deactivate the Wi-Fi interface at low temperatures.
Charging release via app
To protect the charging station against unauthorized access, you can activate the Load release via app as of firmware version 1.02.##.R. After activation, the charging station is locked and each charging process must be released via the SMA Energy App. Charging approval applies to the active charging process. When charging is complete, the charging station is locked again.
Activation can be performed during commissioning via the installation wizard under Load settings or during operation via the user interface under Device configuration.
Device Key (DEV KEY)
The device key allows you to reset the administrator account and assign a new password if you forget the administrator password for the product. The device key can be used to prove the identity of the product in digital communication. The Device Key is located on the back of the quick reference guide that comes with the product. Keep the device key safe in case you forget the administrator password.
Digital inputs
The charging station is equipped with digital inputs as standard.
The digital input X1300 is intended for connection of a ripple control receiver or remote terminal unit for control of the charging station by the grid operator.
Digital input X1301 can be used to connect a fast stop switch to control the charging station by the grid operator or a key switch or RFID card reader to enable charging.
SMA Smart Connected
SMA Smart Connected is the free monitoring of the product via the SMA Sunny Portal. Thanks to SMA Smart Connected, the operator and qualified person will be informed automatically and proactively about product events that occur.
SMA Smart Connected is activated during registration in Sunny Portal. In order to use SMA Smart Connected, it is necessary that the product is permanently connected to Sunny Portal and the data of the operator and qualified person is stored in Sunny Portal and up-to-date.