Mounting the Inverter

Qualified person

Additionally required mounting material (not included in the scope of delivery):

  • For mounting:

    • 4 screws that are suitable for the support surface and the weight of the inverter

    • 4 washers suitable for the screws

    • Where necessary, 4 screw anchors suitable for the support surface and the screws

  • For the transport:

    • 2 eye bolts (M12)

Procedure:

  1. Align the mounting bracket using a spirit level and mark the drilling positions on the profile rails.
  2. Drill the drill holes at the marked positions (Ø=12 mm).
    3. 15921713292
  3. Attach the mounting bracket to the wall using the heavy-duty anchors.
    4. 15921713676
  4. If the inverter is to be hooked into the mounting bracket without using lifting gear, lift the inverter into the mounting bracket.
    5. 16126123660
  5. If the inverter is to be hooked into the mounting bracket using lifting gear, screw the eye bolts into the 2 upper threaded holes on the right-hand and left-hand side of the inverter and attach the lifting gear to them. The lifting gear and the eye bolts must be suitable to take the weight of the inverter.
    6. 15921714060
  6. Attach the inverter to the mounting bracket (M5x12, tightening torque: 2.5 Nm).
    Recommended clearances for mounting
    Electrical Connection