General Data


Width x height x depth, with Electronic Solar Switch

470 mm x 730 mm x 240 mm

Weight of STP 5000TL-20 / 6000TL-20 / 7000TL-20 / 8000TL-20 / 9000TL-20 / 10000TL-20

37 kg

Weight of STP 12000TL-20

38 kg

Length x width x height of the packaging

798 mm x 598 mm x 398 mm

Transport weight of STP 5000TL-20 / 6000TL-20 / 7000TL-20 / 8000TL-20 / 9000TL-20 / 10000TL-20

40 kg

Transport weight of STP 12000TL-20

41 kg

Climatic category in accordance with IEC 60721-3-4

4K4H

Environmental category

Outdoors

Pollution degree outside the enclosure

3

Pollution degree inside the enclosure

2

Operating temperature range

-25°C to +60°C

Maximum permissible value for relative humidity, non-condensing

100 %

Maximum operating altitude above mean sea level (MSL)

3000 m

Typical noise emission

≤40 dB(A)

Power loss in night mode

1 W

Maximum data volume per inverter with Speedwire/Webconnect

550 MB/month

Additional data volume when using the Sunny Portal live interface

600 kB/hour

Topology

Transformerless

Cooling method

SMA OptiCool

Fan connection

Designed for safe disconnection in accordance with DIN EN 62109

Degree of protection for electronics in accordance with IEC 60529

IP65

Protection class in accordance with IEC 61140

I

Grid configurations

TN-C, TN-S, TN-C-S, TT (when VN_PE < 20 V)

Approvals and national standards, as per 06/2017*

AS 4777.2:2015, AS 4777.3, CE, CEI 0-21:2016, C10/11:2012, DIN EN 62109-1, EN 50438, G59/3, G83/2, IEC 61727/MEA, IEC 62109-2, NEN EN 50438, NRS 097-2-1, PPC, PPDS, RD 661/2007, RD 1699:2011, SI 4777, UTE C15-712-1, VDE0126-1-1, VDE-AR-N 4105, VFR 2013, VFR 2014

* AS 4777.3: If DRM support is specified, the inverter may only be used in conjunction with a Demand Response Enabling Device (DRED).
CEI 0-21: only permitted with external decoupling protection.
C10/11:2012: only possible if the three-phase line-to-line voltage is 400 V.
IEC 61727/MEA: applies only to the STP 9000TL-20.
EN 50438: does not apply to all national appendices of EN 50438.
IEC 62109-2: This standard requires that either the multifunction relay in the inverter is used as fault indicator or that the inverter is connected to Sunny Portal and that the fault alert is activated in Sunny Portal.
NRS 97-2-1: This standard requires a separate label be attached to the AC distribution board to indicate the AC-side disconnection of the inverter in case of a grid failure (for further details, see NRS 97-2-1, Sect. 4.2.7.1 and 4.2.7.2).