Configuring the Modbus Function

The Modbus interface is deactivated by default and the communication ports 502 set. In order to access SMA invertes with SMA Modbus^® or SunSpec^® Modbus^®, the Modbus interface must be activated. After activating the interface, the communication ports of both IP protocols can be changed.

For information on commissioning and configuration of the Modbus interface, see the Technical Information "SMA Modbus® Interface" or in the Technical Information "SunSpec® Modbus® Interface" at www.SMA-Solar.com.

Data security during activated Modbus interface

If you activate the Modbus interface, there is a risk that unauthorized users may access and manipulate the data or devices in your PV system.

1. Take appropriate protective measures such as:

• Set up a firewall.

• Close unnecessary network ports.

• Only enable remote access via VPN tunnel.

• Do not set up port forwarding at the communication port in use.

• In order to deactivate the Modbus interface, reset the inverter to default settings or deactivate the activated parameter again.

Procedure:

• Activate the Modbus interface and adjust the communication ports if necessary (see the Technical Information "SMA Modbus® Interface" or "SunSpec® Modbus® Interface" at www.SMA-Solar.com).