Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary switches in the inverter or via a communication product. This section describes the procedure for configuration and gives an overview of the steps you must perform in the prescribed order.
|
Procedure |
See | |
|---|---|---|
|
|
If the display language is not set correctly, adjust the settings. | |
|
|
If you want to integrate the inverter into a Speedwire network, connect the inverter to the network. | |
|
|
Integrate the inverter into the network. | |
|
|
To manage the PV system data or to set the inverter parameters, capture the inverter in a communication product. |
Manual of the communication product at www.SMA-Solar.com |
|
|
Change the system time and system password. |
Manual of the communication product at www.SMA-Solar.com |
|
|
If a residual-current device with a tripping threshold of 30 mA was specified and has been installed, set the tripping threshold of the residual-current device. |
> Setting the Tripping Threshold of the Residual-Current Device |
|
|
If using the multifunction relay, ensure that the operating mode is set correctly and adjust any further settings for the operating mode as necessary. | |
|
|
For partially shaded PV modules and depending on the given shading situation, you should set the interval at which the inverter optimizes the MPP of the PV system. | |