User Manual
Operation of the User Interface of Products powered by ennexOS
- Information on this Document
- Safety
- Operation notes
- Design of the User Interface
- Establishing a Connection to the User Interface of Inverters
- Establishing a Connection to the User Interface of Communication Products
- At system level with Data Manager M as System Manager
- Configuring Service Access
- User Management
- Device Administration
- Parameter
- Information on Parameter Settings with System Managers
- Changing parameters
- Firmware Update
- Open-Loop and Closed-Loop Control via Digital Inputs
- Control of external devices via Modbus
- Parameters for country data set
- Parameters for arc-fault circuit interrupter (AFCI)
- Parameters for grid and PV system protection
- Setting of SMA ShadeFix
- Check fan function
- Q on Demand 24/7
- Parameters for Rapid Shutdown Function (US)
- Restart the inverter via the user interface
- Information on Parameter Settings with System Managers
- Grid management service
- Active Power Limitation
- Separated reference values for the active power limitation
- Configuring active and reactive power setpoints
- Configure additional specifications from the grid operator for the country data set.
- Configure additional direct seller's specifications for the country data set.
- Setting Zero Export
- Active Power Limitation
- I/O configuration
- Energy management
- Activating the energy management
- Deactivating the energy management
- Predefined operating modes
- Available operating modes
- Setting options for peak load shaving
- Setting options for the multiuse function
- Add new operating mode
- Setting backup operation
- Backup Configuration
- Configuring the battery
- Set battery fallback behavior when energy management is disabled
- Create a new schedule
- Export schedules
- Import schedules
- Activating the energy management
- Update and backup
- Generating the I-V Characteristic Curve
- Resetting the product to default setting
- Troubleshooting
- Obsolete or incorrect measured values are displayed
- Not all devices are being detected
- Parameter changes via the device settings or a parameter adjustment are not confirmed
- The product cannot be registered in Sunny Portal
- The firmware of a connected SMA product was not updated during a firmware update
- No data are displayed on the user interface of the product
- Manual restart after electric arc
- Create Diagnostics Data
- Obsolete or incorrect measured values are displayed