Decommissioning the Product

Procedure:

  1. Disconnect the inverter from voltage sources (see inverter manual).
  2. Switch off the battery (see manual from the battery manufacturer).
  3. Disconnect the automatic transfer switching device from voltage sources.
  4. Open the lid of the automatic transfer switching device. To do this, press on the left side of the box.
  5. Remove the installation cover of the automatic transfer switching device. To do this, loosen the 4 screws (TX20) for fastening the installation cover using a suitable tool.
  6. Remove the connected cables from the automatic transfer switching device.
  7. Pull the cable out of the enclosure opening holes.
  8. Loosen the screw for fastening the automatic transfer switching device on the wall mounting bracket.
  9. Remove the automatic transfer switching device from the wall mounting bracket.
  10. Use a suitable screwdriver to loosen the screws securing the wall mounting bracket and remove the washers.
  11. Remove the wall mounting bracket.
    Troubleshooting
    Disposal