Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary switches in the inverter or via a communication product. This section describes the procedure for configuration and gives an overview of the steps you must perform in the prescribed order.
|
Procedure |
See | |
|---|---|---|
|
|
If the display language is not set correctly, adjust the settings. | |
|
|
If the inverter is equipped with a Speedwire/Webconnect data module, integrate the inverter in a Speedwire network and register it in Sunny Portal, if necessary. |
Manual of the communication product at www.SMA-Solar.com |
|
|
To manage the PV system data or to set the inverter parameters, capture the inverter in a communication product. |
Manual of the communication product at www.SMA-Solar.com |
|
|
Change the system time and system password. |
Manual of the communication product at www.SMA-Solar.com |
|
|
If you would like to use the self-learning string-failure detection, activate the string-failure detection. | |
|
|
Set the active power limitation in case of PV system control failure. |
> Setting the Active Power Limitation in case of PV System Control Failure |
|
|
Reduce the attenuation of ripple control signals. | |
|
|
For partially shaded PV modules and depending on the given shading situation, you should set the interval at which the inverter optimizes the MPP of the PV system. | |