ENGLISH
ENGLISH
DEUTSCH
日本語
Validity
This document is valid for:
STP 50-JP-40 (Sunny Tripower CORE1-JP) from firmware version ≥ 3.00.00.R
Information on this Document
Target Group
Table of Contents
toggle menu
Information on this Document
Validity
Target Group
Content and Structure of this Document
Levels of Warning Messages
Symbols in the Document
Typographies in the document
Designations in the Document
Additional Information
Safety
Intended Use
IMPORTANT SAFETY INFORMATION
Scope of delivery
Product Overview
Product Description
Symbols on the Product
Interfaces and Functions
LED Signals
Mounting
Requirements for Mounting
Mounting the product
Electrical Connection
Overview of the Connection Area
AC Connection
Requirements for the AC Connection
Connecting the Inverter to the Utility Grid
Connecting the Network Cables
Connecting the Multifunction Relay
Procedure for connecting the multifunction relay
Operating Modes of the Multifunction Relay
Connection Options
Connection to the Multifunction Relay
DC connection
Requirements for the DC Connection
Assembling the DC Connectors
Connecting the PV Array
Disassembling the DC Connectors
Commissioning
Commissioning Procedure
Commissioning the Inverter
Selecting a configuration option
Operation
Establishing a connection to the user interface
Establishing a Direct Connection via Ethernet
Establishing a direct connection via WLAN
Establishing a Connection via Ethernet in the local network
Establishing a Connection via WLAN in the Local Network
Logging In and Out of the User Interface
Start Page Design of the User Interface
Displaying and Downloading the Stored Data
Activating the Smart Inverter Screen
Starting the Installation Assistant
Activate WPS Function
Switching WLAN On and Off
Switching the Dynamic Power Display Off
Changing the Password
Changing Operating Parameters
Configuring the Country Data Set
Configuring the Active Power Mode
Configuring Q on Demand 24/7
Manual Restart
Activating Manual Restart
Configuring the SMA I/O Module
Configuring the Multifunction Relay
Reading out the Cause for Interruption of Feed-in Operation
Activating Feed-In Operation after Grid Fault
Changing the Operating Mode of the Multifunction Relay
Configuring the Modbus Function
Setting SMA ShadeFix
Setting the Rated Residual Current of the Residual-Current Device
Saving the Configuration in a File
Adopting a Configuration from a File
Disconnecting the Inverter from Voltage Sources
Clean the product
Troubleshooting
Event messages
Checking the PV System for Ground Faults
Decommissioning the Inverter
Technical Data
Accessories
Contact
