Configuration Procedure
Once you have commissioned the inverter, you may have to adjust various settings via the rotary switches in the inverter or via a communication product. This section describes the procedure for configuration and gives an overview of the steps you must perform in the prescribed order.
|
Procedure |
See | |
|---|---|---|
|
|
If the display language is not set correctly, adjust the settings. | |
|
|
In order to use the Webconnect function, integrate the inverter into the network. | |
|
|
To manage the PV system data or to set the inverter parameters, capture the inverter in a communication product. |
Manual of the communication product at www.SMA-Solar.com |
|
|
In order to receive control commands of the grid operator via SMA Speedwire/Webconnect for PV systems in Italy, set the parameters. |
Manual of the Speedwire/Webconnect interface |
|
|
Change the system time and system password. |
Manual of the communication product at www.SMA-Solar.com |
|
|
If the inverter is installed in an IT network or another grid configuration where deactivation of the grounding conductor monitoring is required, deactivate the grounding conductor monitoring. | |
|
|
For partially shaded PV modules and depending on the given shading situation, you should set the interval at which the inverter optimizes the MPP of the PV system. | |