Mounting the Product on the Wall

Additionally required mounting material (not included in the scope of delivery):

  • 4 screws Take note of the diameter of the holes in the wall mounting brackets, the condition of the wall and the weight of the product.

  • If necessary: screw anchors and washers (depending on support surface)

Procedure:

    5653754380
  1. Attach both wall mounting brackets to the back of the product using two of the supplied screws each. Keep in mind that the holes for attachment to the wall are located on the outside and stick out from the product to the rear.
  2. Align the product horizontally on the wall and use the wall mounting bracket to mark the position of the drill holes.
  3. Drill the marked drill holes.
  4. Insert screw anchors into the drill holes if the support surface requires them.
    5. 5688560524
  5. Insert the supplied screws through the holes and tighten. Use the washers if necessary.
  6. Ensure that the product is securely in place.
    <  Mounting the Product on the DIN Rail
    >  Connection